,

5/8 inch Diameter Square U-Bolt


Compare

5/8 inch Diameter Square U-Bolt

Please note the inside corners of a Square Custom U-Bolt are slightly rounded and are not perfectly square as pictured.

$6.86$28.00

Clear

5/8 inch Diameter Square U-Bolt is Custom Bent from the choices you make here. Please read the directions carefully.

5/8 inch Diameter Square U-Bolt
  • Pricing includes Extra Deep Nuts and Hardened Thick U-bolt Washers
  • Custom bent u-bolts are non-returnable.

 

Measure your u-bolt using the image above to to get your pricing.

  • “C” = Inside Width    (measure inside width)
  • “L” = Inside Length   (measure from the highest point inside to the bottom of the leg of u-bolt)
  • “T” = Approximate Thread Length is calculated by multiplying 2 X “L” plus “C” (which equals the overall length of rod material before bending)
    • Approximate thread lengths are predetermined and are listed below;
      • (Total rod length = Thread length on each leg)
        • 8″   to 20″ = 2″-3″
        • 22″ to 30″ = 4″
        • 32″ to 48″ = 6″
SKU: 5/8 inch dia U-Bolt Square Categories: , Tags: ,
Weight 0.94 lbs
Inside Width

2.5in, 3in, 3.25in, 3.5in, 4in, 5in, 6in

Inside Length

5in, 6in, 7in, 8in, 9in, 10in, 11in, 12in, 13in, 14in, 15in, 16in, 17in, 18in, 19in, 20in, 21in, 22in

ITEM: is usually in stock. If u-bolt is for suspension use, re-tighten after the first 500-1000 miles. As new or repaired springs wear in, some settling of the spring pack will occur. Even a minor amount of this settling can cause a dramatic reduction in clamping force.

Specs: 

  • .625 (5/8) inch threads with a SAE thread pitch of 18 TPI
  • U-bolts up to 9/16 are Grade 5, while 5/8 and above are Grade 8.

We do not stock any form of stainless steel material. We do not offer any type of plating or galvanizing. All u-bolts we make are oil finish.

Physical properties:

150,000 PSI Minimum Tensile Strength; 130,000 PSI Minimum Yield Strength; 120,000 PSI Proof Load; 35% Reduction of Area; 10% Elongation. U-Bolts produced to SAE-J429 specification. This material is a cold drawn, stress relieved, micro-alloyed, 1541 modified steel. Please note that not all bending widths can be ordered on our web site.

For other information on our U-Bolts, please visit our U-Bolt information page.

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “5/8 inch Diameter Square U-Bolt”

There are no reviews yet.